DF Robot Cable Slitter

by iCON

Many DIY lightgun builds are very limited on space. Removing the outer insulation from the DF Robot camera cable makes it easier to route the camera wires. Install an Xacto knife, set the depth using the gauge block, lock the knife in place and pull the camera cable through the channel to form a slit.

The author marked this model as their own original creation.
This work is licensed under a CC BY-NC Creative Commons (4.0 International License)

Say thanks by giving iCON a tip! Why?

STLs
Hardware
Guides
Gallery
Discuss
Polls
Wiki

3 parts have been uploaded for the DF Robot Cable Slitter, some may be alternative versions of the same part.


Depth Gauge Block rev.1 by iCON on 07 Mar 2024 View 3d Model Download STL File	Sets the knife blade depth to about 0.8mm Suggested settings: Print as shown in the STL file Support is not required
Knife Clamp rev.1 by iCON on 07 Mar 2024 View 3d Model Download STL File	Locks the knife in place Suggested settings: Print as shown in the STL file Support is not required
Knife Holder rev.1 by iCON on 07 Mar 2024 View 3d Model Download STL File	For best results, use a new Xacto knife blade. Insert (2) M3x5(OD)x6(L) heat set inserts in the holes then use (2) M3x12 screws. If you don’t have heat set inserts, you can use (2) M3x30 screws with washers and nuts instead. Suggested settings: Print as shown in the STL file Support is not required