iCON2
3D Printed Lightgun by iCON
Changes include Wii d-pad and linear rail rather than round rail. All files same as iCON1 except for the Slide, Bearing Mount and Bearing Clamp. D-pad changes are still a work in progress.
For 3D parts not shown below, use the part from the iCON1 lightgun.
The author marked this model as their own original creation.
This work is licensed under a CC BY-NC-SA Creative Commons (4.0 International License)
Say thanks by giving iCON a tip! Why?
7 parts have been uploaded for the , some may be alternative versions of the same part.
| Bearing Clamp rev.1 by iCON on 06 Feb 2024 | Insert four M3x5 heat set inserts into the sides of the bearing clamp. Use M3x12mm screws to secure the slide to the bearing clamp. To avoid pulling the heat set inserts out of the bearing clamp, do not overtighten the screws. Suggested settings:
| 
|
| Bearing Mount rev.1 by iCON on 06 Feb 2024 | Suggested settings:
| 
|
| Front Frame rev.1 by iCON on 06 Feb 2024 | Suggested settings:
|
 |
| Rear Frame rev.1 by iCON on 06 Feb 2024 | Suggested settings:
|
|
| Slide rev.1 by iCON on 06 Feb 2024 | Suggested settings:
| 
|
| Trigger Guard (2 piece) rev.1 by iCON on 06 Feb 2024 | 2 piece trigger guard courtesy of Discord user Krzysztof Papuga with rounded edges and prints without supports. Suggested settings:
|
|
| Trigger Guard Pin rev.1 by iCON on 06 Feb 2024 | Suggested settings:
|
|
No Deprecated 3d Parts found for the
No Guides found
Image Galleries
Video Galleries
No Video Galleries found
